Easily open or close your garage door with a double flash of your vehicle's high beam switch - no more remotes to lose! The digitally encrypted signals and rolling code technology provide the ultimate security. Flash2Pass works with virtually any garage door opener manufactured since 1982 and offers easy, do-it-yourself installation. It even works with motorcycles, ride on lawn mowers etc- any vehicle that uses a 6- or 12-volt battery. Add a transmitter for every vehicle in your household (sold separately) - up to seven transmitters can operate a single receiver
This is the complete set that consists of the patented transmitter, corresponding receiver, all installation hardware and easy do-it-yourself installation instructions.
The Transmitter is a radio frequency device that is mounted under the bonnet
of the car. It is relatively small, approximately 2” x 2” x ¾” and is attached
under the bonnet with either the enclosed screws, or the plastic zip tie. The
wires are attached with Posi-Tap™ connectors to the headlight high beam positive
wire and to the ground wire. The Flash2Pass™ transmitter is non-polarized so you
can attach either wire to the headlight wires.
The Flash2Pass™ receiver is designed to replace the pushbutton inside your
garage. If you have additional functions on your pushbutton that you would like
to keep, the receiver can be installed next to your original pushbutton and
“piggybacked” to it.
The Flash2Pass™ transmitter and receiver are packaged as a set that is
pre-programmed at the factory, or they are available individually. For instance,
if you had a two-car garage with one large door for both bays, you would buy one
set and an additional transmitter. The additional transmitter would be installed
in the second vehicle and the receiver programmed to accept it.
Say you had a vacation home with a garage door opener. You could get an
additional Flash2Pass™ receiver for it and then program your car to it. That
way, you wouldn’t have to remember to bring the remote with you. It will always
be at your fingertips…both at home and on vacation.
Now, if you live in a gated community and the community installed the F2P
Integrated Control Access System, you would be able to access the community
gate, and your individual garage. We call this the “gate to garage” concept.
Also if you worked in a place that had some sort of parking control and the F2P
ICAS were in place, you again could use your Flash2Pass™ transmitter to gain
access, assuming you were authorized and/or programmed into the receiver.